Manley Reference Silver

The Manley Silver Tube Microphone is large condenser microphone inspired by the legendary Sony C-37A and built in collaboration with Josephson.

The Manley Silver Tube Microphone uses a capsule designed by David Josephson who has provided a stunning recreation of the C-3 capsule originally used on the C-37 microphone in the ‘50s. This capsule is single-ended and boasts an adjustable acoustic chamber on the back allowing the user to change between omni and cardioid polar patterns. This capsule delivers a rich a creamy tone associated with the original Sony microphone.

Inside the microphone, lies a unique circuit design which combines a FET and vacuum tube cathode used to amplify the signal before hitting Manley’s IRON transformer. This design provides a bit less output than other microphones and can, therefore, accommodate loud sources very well.

The power supply has been specifically designed for audio fidelity with all regulated lines, super low impedance rails and no 50Hz/60Hz ripple component present in the chassis. It works at any voltages between 90V and 250V so all you need to do is plug it in.

This microphone offers a rich and warm sound that will complement female vocals and saxophones particularly well without any boxiness or sibilance. It will also impart its sonic glory on drum overheard with a warm mid frequency response shaving off the harshness produced by cymbals when used with other microphones. Its dark tone means that it can often be used instead of a ribbon microphone.

Manley Silver Tube Microphone Main Features:

• Condenser Transducer based on vintage Sony C-37A Hand Made in USA by Josephson Audio

• Single-Sided Large Diaphragm Capsule Edge Tensioned

• 5 Micron Evaporated Gold Diaphragm 1" diameter

• Dual Pattern Cardioid or Omni Directional adjustable via vent on the backplate

• 5670 Internal Vacuum Tube Head Amplifier

• Constant Current Source for Tube Minimizes Noise and Tube Selection

• Hand Wound Nickel Core Manley Iron Output Transformer

• Output Impedance: 30 Ohms

• High Pass Filter Switch -3dB @ 55Hz 6dB/8va

• FREQUENCY RESPONSE: 10Hz-30kHz, AMP to 60kHz

• MAXIMUM INPUT SPL: 150 dB SPL at Capsule

• SENSITIVITY: 7mV/Pa

• AMPLIFIER TYPE: 2 Triode Gain Block Lo Z Output

• OUTPUT POLARITY: Balanced XLR, Pin 2 Hot, Pin 3 Low

• AMPLIFIER DISTORTION: Less Than 0.05 % THD+N BW 22-22 kHz (1kOhm Load, 1kHz -40dBV Output)

• AMPLIFIER NOISE: Typically -108 dBV “A Weighted”

• BODY: Etched Silver Anodized Aluminum

• Weight: 1.5 lbs (mic)

• Weight: 2 lbs (PSU)

• Size: 2" x 9.7" x 4.5" (mic including suspension)

• Size: 5" x 8.2" x 3.4" (PSU)

• Custom Designed Outboard Switched Mode PSU 90V ~ 250VAC Universal Voltage Operation 50Hz-60Hz

• Power Consumption: 15 Watts

• PSU External Mains Fuse: 5mm X 20mm, 2A @ 250V, CERAMIC, Slo-Blo